MakerSolidSketch tool
Circle
Draw a closed circular sketch profile by diameter from a configurable bound point or center.
Purpose
Draw a closed circular sketch profile by diameter from a configurable bound point or center.
Where to find it
Start or edit a sketch, open Draw, and choose Circle.
Selection
- Tap the configured Draw Anchor and drag or tap to define the circle.
Steps
- Choose Draw Anchor and optionally Construction Mode.
- Place the anchor, enter Diameter if desired, and tap Apply.
Options
Result
Apply creates one editable circle that forms a closed profile when not construction geometry.
Editing
Edit its Radius or Diameter, move its center, or apply Concentric, Tangent, Equal, and Fix constraints.
Troubleshooting
The circle is offset from the intended center.
Set Draw Anchor to Center before placement or move and constrain the center afterward.